Chowist Web Search

Search results

1. Results From The WOW.Com Content Network

2. Bridged and paralleled amplifiers - Wikipedia

   en.wikipedia.org/wiki/Bridged_and_paralleled...

   A bridge-parallel amplifier topology is a hierarchical combination of the bridged and paralleled amplifier topologies, with at least four single-ended channels needed to produce one bridge-parallel channel. The two topologies complement each other in that the bridging allows for higher voltage output and the paralleling provides the current ...

3. Bi-amping and tri-amping - Wikipedia

   en.wikipedia.org/wiki/Bi-amping_and_tri-amping

   Bi-amping - An active crossover with two amplifiers. Bi-amping and tri-amping is the practice of using two or three audio amplifiers respectively to amplify different audio frequency ranges, with the amplified signals being routed to different speaker drivers, such as woofers, subwoofers and tweeters. With bi-amping and tri-amping, an audio ...

4. Amplifier - Wikipedia

   en.wikipedia.org/wiki/Amplifier

   Amplifier. A McIntosh stereo audio amplifier with output power of 50 watts per channel used in home component audio systems in the 1970s. [ 1] Amplification means increasing the amplitude (voltage or current) of a time-varying signal by a given factor, as shown here. The graph shows the input (blue) and output voltage (red) of an ideal linear ...

5. Class-D amplifier - Wikipedia

   en.wikipedia.org/wiki/Class-D_amplifier

   The first class-D amplifier was invented by British scientist Alec Reeves in the 1950s and was first called by that name in 1955. The first commercial product was a kit module called the X-10 released by Sinclair Radionics in 1964. However, it had an output power of only 2.5 watts. The Sinclair X-20 in 1966 produced 20 watts but suffered from ...

6. AV receiver - Wikipedia

   en.wikipedia.org/wiki/AV_receiver

   The term "receiver" basically refers to an amplifier, typically at least a two-channel stereo model, that has a built-in radio tuner. With A/V receivers, the basic functionality is to receive an audio signal, amplify the audio signal to drive multiple speakers, and allow pass-through of the corresponding video signal to a display device such as ...

7. Jim Kelley Amplifiers - Wikipedia

   en.wikipedia.org/wiki/Jim_Kelley_Amplifiers

   Jim Kelley Amplifiers is the trademark for the vacuum tube guitar amplifiers designed by Jim Kelley and manufactured by his company Active Guitar Electronics of Tustin, California between the years of 1978 and 1985. [1] Approximately 600 of these amps were built during that time. [2] The single-channel version of the amplifier employed modest ...