Search results
Results From The WOW.Com Content Network
ATA 100. ATA 100 contains the reference to the ATA numbering system which is a common referencing standard for commercial aircraft documentation. This commonality permits greater ease of learning and understanding for pilots, aircraft maintenance technicians, and engineers alike. The standard numbering system was published by the Air Transport ...
An electrical wiring interconnect system ( EWIS) is the wiring system and components (such as bundle clamps, wire splices, etc.) for a complex system. The term originated in the aviation industry but was originally designated as Electrical Interconnection Systems (EIS). [1] The change from EIS to EWIS was done to emphasize the focus on the ...
ATA Spec 100 was originally published in 1956. It established an industry-wide numbering scheme to organize aviation technical documentation as well as content and formatting guidelines for its conventional printed distribution. ATA Spec 2100 focused on electronic data exchange implemented in SGML . iSpec 2200 was first published in 2000.
A conventional fixed-wing aircraft flight control system ( AFCS) consists of flight control surfaces, the respective cockpit controls, connecting linkages, and the necessary operating mechanisms to control an aircraft's direction in flight. Aircraft engine controls are also considered flight controls as they change speed.
Aircraft continuous airworthiness monitoring. ACARS. Aircraft Communications Addressing and Reporting System. ACAS. Airborne collision avoidance system. ACC. Area control centre [1] ACC. Active clearance control.
Fly-by-wire ( FBW) is a system that replaces the conventional manual flight controls of an aircraft with an electronic interface. The movements of flight controls are converted to electronic signals transmitted by wires, and flight control computers determine how to move the actuators at each control surface to provide the ordered response.
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with ...
Aircraft engine controls. Aircraft engine controls provide a means for the pilot to control and monitor the operation of the aircraft's powerplant. This article describes controls used with a basic internal-combustion engine driving a propeller. Some optional or more advanced configurations are described at the end of the article.