Search results
Results From The WOW.Com Content Network
In thermodynamics, the Volume Correction Factor (VCF), also known as Correction for the effect of Temperature on Liquid (CTL), is a standardized computed factor used to correct for the thermal expansion of fluids, primarily, liquid hydrocarbons at various temperatures and densities. [1] It is typically a number between 0 and 2, rounded to five ...
Viscosity depends strongly on temperature. In liquids it usually decreases with increasing temperature, whereas, in most gases, viscosity increases with increasing temperature. This article discusses several models of this dependence, ranging from rigorous first-principles calculations for monatomic gases, to empirical correlations for liquids.
The relationship between specific gravity (s.g.; i.e., water-specific gravity, the density relative to water) and degrees Baumé is a function of the temperature. Different versions of the scale may use different reference temperatures. Different conversions formulae can therefore be found in various handbooks.
Specific gravity for liquids is nearly always measured with respect to water at its densest (at 4 °C or 39.2 °F); for gases, the reference is air at room temperature (20 °C or 68 °F). The term "relative density" (abbreviated r.d. or RD ) is preferred in SI , whereas the term "specific gravity" is gradually being abandoned.
Thermal diffusivity. In heat transfer analysis, thermal diffusivity is the thermal conductivity divided by density and specific heat capacity at constant pressure. [1] It is a measure of the rate of heat transfer inside a material. It has units of m 2 /s. Thermal diffusivity is usually denoted by lowercase alpha ( α ), but a, h, κ ( kappa ...
Energy density. In physics, energy density is the amount of energy stored in a given system or region of space per unit volume. It is sometimes confused with energy per unit mass which is properly called specific energy or gravimetric energy density . Often only the useful or extractable energy is measured, which is to say that inaccessible ...
The density of butane is highly dependent on temperature and pressure in the reservoir. [18] For example, the density of liquid butane is 571.8±1 kg/m 3 (for pressures up to 2MPa and temperature 27±0.2 °C), while the density of liquid butane is 625.5±0.7 kg/m 3 (for pressures up to 2MPa and temperature -13±0.2 °C).
Data obtained from Lange's Handbook of Chemistry, 10th ed. and CRC Handbook of Chemistry and Physics 44th ed. The annotation, d a °C/ b °C, indicates density of solution at temperature a divided by density of pure water at temperature b known as specific gravity. When temperature b is 4 °C, density of water is 0.999972 g/mL. % wt. methanol.