Search results
Results From The WOW.Com Content Network
Packet Tracer is commonly used by NetAcad students, since it is available to download after creating a free account. [9] However, due to functional limitations, it is intended by Cisco to be used only as a learning aid, not a replacement for Cisco routers and switches . [ 8 ]
Cisco Eos, a software platform; Packet Tracer, didactic network simulator; Cisco Network Magic Pro; Cisco Security Manager; Cisco Security Device Manager (SDM) Cisco Security Prime Device Manager; Cisco Prime Infrastructure; Cisco Adaptive Prime Security Device Manager (for the ASA-CX) Cisco Firepower Management Center (for the ASA FirePOWER)
In computer network research, network simulation is a technique whereby a software program replicates the behavior of a real network. This is achieved by calculating the interactions between the different network entities such as routers, switches, nodes, access points, links, etc. [1] Most simulators use discrete event simulation in which the modeling of systems in which state variables ...
Often the route a packet needs to take through a network is not immediately available. In that case, the packet is queued and waits until a link is free. The physical link technologies of packet networks typically limit the size of packets to a certain maximum transmission unit (MTU). A longer message may be fragmented before it is transferred ...
Wireshark is very similar to tcpdump, but has a graphical front-end and integrated sorting and filtering options.. Wireshark lets the user put network interface controllers into promiscuous mode (if supported by the network interface controller), so they can see all the traffic visible on that interface including unicast traffic not sent to that network interface controller's MAC address.
The outgoing network packet traffic is distributed according to the current load (computed relative to the speed) on each network interface slave. Incoming traffic is received by one currently designated slave network interface. If this receiving slave fails, another slave takes over the MAC address of the failed receiving slave.
Cisco's implementation of traceroute also uses a sequence of UDP datagrams, each with incrementing TTL values, to an invalid port number at the remote host; by default, UDP port 33434 is used. An extended version of this command (known as the extended traceroute command) can change the destination port number used by the UDP probe messages.
Dynamips is an emulator computer program that was written to emulate Cisco routers. It was developed by Christophe Fillot, who began working on it in August 2005. Dynamips runs on FreeBSD, Linux, Mac OS X and Windows. It emulates the hardware of the Cisco series routing platforms by directly booting an actual Cisco IOS software image into the ...